Planned Maintenance

Get the most out of your equipment (forklifts, docks & much more). These plans have been created to help you prolong the life of your machine, maintain a higher resale value and to keep compliance with OSHA safety regulations. Here are just a few reasons signing up for planned maintenance can save you money.

• Reduce downtime & minimize costly repairs when you find issues early on.
• Keep your employees safe and lower the chance of expensive workplace accidents with routine inspections.
• Get a greater trade in or resell value when you replace your equipment.
• Pay one flat rate for labor instead of by the hour.

30 Point Forklift Inspection

1. Check for operation
2. Visual inspection
3. Horn
4. Lights
5. Check hydraulic system
6. Check all switches
7. Check forward & reverse lever
8. Check/test brake & parking brake (adjust if needed)
9. Check cylinder
10. Check for leaks
11. Check & top off all fluids
12. Check steering
13. Check all wheels
14. Check & lubricate mast, chain & grease fittings
15. Check radiator & reservoir
16. Check transmission & operation
17. Blowout radiator core & clean machine with compressed air
18. Check spark plug, wire cap & rotor
19. Check & adjust carburetor and governor (if needed)
20. Check & adjust timing (if needed)
21. Check LP system
22. Check or replace air filter
23. Check or replace motor oil & filter
24. Check SCR system operation
25. Check & inspect battery, water level
26. Check battery cables & connectors
27. Check & inspect contactors
28. Check & inspect all electric motor brushes (when accessible)
29. Check charging system (built-in)
30. Check fork wear

25 Point Dock Inspection

1. Overall Visual Inspection
2. Check for operation
3. Clean debris from pit
4. Inspect deck and lip
5. Inspect toe guards
6. Inspect weather seals
7. Tighten all nuts & bolts
8. Inspect all welds
9. Inspect rear hinge
10. Inspect & lube front hinge
11. Inspect hydraulic cylinders and hoses
12. Inspect limit switches and arms
13. Inspect & lubricate cylinder pivots
14. Inspect sub frame
15. Inspect fluid levels
16. Inspect valve block in motor/pump
17. Inspect hold down assembly
18. Inspect cross traffic/safety legs
19. Inspect release chains
20. Inspect and lubricate lift arm
21. Inspect & lube lift arm roller
22. Inspect all electrical connections
23. Inspect control panel
24. Inspect bumpers
25. Cycle leveler for proper operation